Let me walk you through how we exposed our ceiling beams and why we chose this option full of character!

So first off our ceilings are 8ft tall so not super duper tall but not bad for how old our house is! We’ve been working on our kitchen renovation and had totally different plans with the ceiling.

Here’s what our kitchen looked like with our normal ceiling. Our washer and dryer were in our kitchen but thank goodness we got those moved upstairs!

Then, we removed this faux wall that was used to hold tiny cabinets so we could design our new kitchen all the way up to the ceiling.

Then, we found that there was original beadboard above the drywall ceiling painted green probably from the 1800’s. I really wanted to keep the beadboard and bring it back to life but if there were any holes or imperfections it would be so hard to make look flawless.

Next we took down the adobe wall that was dividing a bedroom and the kitchen. We mostly used the bedroom as an office but decided to expand the kitchen and create a dining room. In order to take down the wall we needed to cut open the ceiling to see if the wall was load bearing.

Great news….the wall was not load bearing! We were able to remove the giant adobe wall and now had a huge hole in the ceiling. My thought was to put new beadboard on the ceiling and have it go the full span of the room. Home Depot has the nifty 4’x8’ sheets of beadboard that are lightweight and seemed easy enough! We would need 13 sheets and it would cost us about $300 for the entire ceiling.

Here’s the view from the other direction with what was left of the original bead board before we took it down.

Looking closer at the beams we realized the old and new look mixed didn’t look the best and it looked pretty crowded with both. The old beams definitely looked more weathered and characteristic but the newer ones were holding up the house and that took priority haha

Now that half the beams are cleared out it’s time for painting! We decided to tape everything off and use a paint sprayer because the thought of rolling or hand painting every nook and cranny made me want to cry…except just wait haha I started out with these super cute goggles and quickly realized I needed our full-on face mask with a breathing filter from all the paint remnants and fumes.

Normally I’ll get a primer and paint in one if I’m just doing a normal paint project but for this job we needed to work smarter not harder. I knew we needed to prime the wood because it would just soak up paint like a sponge and we’d be spending wayyyy more on paint than we needed to. I did half of the ceiling and started being able to see the potential! Thank goodness because there’s no going back now haha

Deciding on a paint color was not fun because there’s only a trillion different shades of white to choose from and that’s where my decisive skills fail me haha after testing different colors I went with “Swiss Coffee”- Behr. It’s a great warm white and my mom has it in her house and ended up being the push for helping me decide!

We bought two gallons of flat ceiling paint and tried to get a system of one person using the roller with extension rod to get the flat parts of the ceiling while the other used the brush to get in the corners and crevices of the beams. We discovered that using more is better and laying it on as thick as we could without it dripping made it cover really well and go faster. The reason we didn’t use the sprayer for the actual paint color is because of the waste factor and how much ends up being sprayed everywhere. We went through 5 gallons of primer and only 1 gallon of paint haha